What breaker and cable for a 1,000 W inverter?
12 V bank: a 125 A DC breaker and 2 AWG (35 mm²) battery cable.
24 V bank: a 63 A DC breaker and 2 AWG (35 mm²) battery cable.
48 V bank: a 32 A DC breaker and 8 AWG (8 mm²) battery cable.
| Battery bank | Most it draws | Breaker (at the battery +) | Battery cable |
|---|---|---|---|
| 12 V | 98.0 A | 125 A DC breaker | 2 AWG (35 mm²) |
| 24 V | 49.0 A | 63 A DC breaker | 2 AWG (35 mm²) |
| 48 V | 24.5 A | 32 A DC breaker | 8 AWG (8 mm²) |
Why these sizes
- An inverter draws the most when the battery is low: 1,000 W ÷ (bank volts × 0.85), the 0.85 covering the low battery voltage and the inverter's own losses.
- The breaker is the next standard size at 125 % of that, so a full load does not trip it, and it sits at the battery's + terminal, where a short would start.
- The cable must be rated for the breaker. At low voltage the currents are large: a higher-voltage bank halves the current and the cable size.
The cable is fine-stranded battery or welding cable, short and the same length on + and −; check the inverter manual for its own fuse rating and cable size, which come first. Most 1,000 W systems are built at 24 V.
Open it on the benchAn off-grid system with its battery breaker: change the inverter and let the safety check size the breaker.
For planning and learning. Use the appliance's nameplate (amps, MCA and MOCP) when you have it, follow your local electrical code, and have a licensed electrician do work on a building's wiring.