Perfboard
Prototype board 24 × 18 holes · 2.54 mm pitch · FR-4, plated through-hole pads on both sides · no strips: holes connect only where you solder · showing the front (component side)
Try it on the benchThe lab drops it on an empty bench and opens its datasheet card.
Typical part: Double-sided prototype board, plated through-holes (e.g. 7 × 9 cm, 24 × 30 holes)
Pins
- A1
- A2
- A3
- A4
- A5
- A6
- A7
- A8
- A9
- A10
- A11
- A12
- A13
- A14
- A15
- A16
- A17
- A18
- A19
- A20
- A21
- A22
- A23
- A24
- B1
- B2
- B3
- B4
- B5
- B6
- B7
- B8
- B9
- B10
- B11
- B12
- B13
- B14
- B15
- B16
- B17
- B18
- B19
- B20
- B21
- B22
- B23
- B24
Ratings and limits
| Pitch | 2.54 mm (0.1 in) |
|---|---|
| Pads | plated through-hole, tinned, both sides |
| Connections | none: every joint is soldered by you |
| Pad current | ≈ 1–2 A per pad; a solder bridge ≈ 10 A; 22 AWG jumper 7 A |
How to use it
Put parts in from the front, bend the leads, flip the board and solder. Join neighbouring pads with a solder bridge, short runs with bare tinned wire, longer runs with insulated hook-up wire. Two holes are only connected if you join them.